If Verdi Had Been A Jeweler
If Verdi Had Been A Jeweler
If Verdi Had Been A Jeweler The Anvil Chorus would have been much quieter. Play your own chorus on this excellent forged jeweler's anvil, which is much smaller than the ones in cartoons. In heavy polished steel, it measures approx 4-1/4” x 1-3/4” x 1-1/8” with a 2-1/4” x 1-1/4” flat working surface for chasing, bending corners and flattening wire to harden it, plus (1) round horn and (1) flat horn with a hole for riveting and beading. Essential for making flattened hook-and-eye clasps with craft wires. Also, a must for teeny-tiny blacksmiths.
If Verdi Had Been A Jeweler, If Verdi Had Been A Jeweler The Anvil Chorus would have been much quieter. Play your own chorus on this excellent
4-1/4 POLISHED STEEL JEWELER'S ANVIL
Products – Tagged Blacksmithing – Jim Bode Tools
Oudtinx Steel Bench Block 4x4 Flat Anvil Jewelers Tool Metal Bench Block for Jewelry & Stamping (4''x4''x3/4'')
Then get these actual horseshoes. These are not those Clydesdale-sized behemoths your grandfather used to toss at iron stakes. These are more like the
4-3/4 IN.X 4-1/2 IN. STEEL HORSESHOE
Vintage Jewelers Anvil 1930s to 1940s Jewelry Makers Tool
SET OF 4 ANVIL, SS 420 MATERIAL, 45-50 HRC, NICLEY MACHINES, VACUUM TREATED, VERY NICE FINISH, GOLDSMITH TOOL
FLAT ANVIL,HI DOME,MEDIUM DOME,LOW DOME SET OF 4 ANVIL FOR JEWELRY MAKING SS 420
VEVOR Single Round Horn Anvil Cast Steel Block Blacksmith Bench Tool 10-60KG Jewelery Making Manual Equipment for Metalsmiths
4-1/4 POLISHED STEEL JEWELER'S ANVIL
Small but mighty, this anvil takes up very little space, but you will use it over and over for your wire working projects. One end is round and tapers from 12mm to 2mm in diameter. The other end has sharp angles for wire bending. The angled end has a hole 3mm diameter hole which you can thread wire through to keep it in place. Top and sides are polished and smooth. 42mm high, 102mm long, 26mm thick.
Beadsmith Solid Stainless Steel Mini Jewelry Anvil Wire Work Tool