Cutting 3mm plywood - Common Problems - LightBurn Software Forum

LE-4040 20w. I have the laser focused at 30mm. I am trying to cut out a very intricate design and am having some problems. On the very small parts it is burning more area than I would like. I am wondering recommended settings. Is it better to run lower power and more passes? Is 3mm too thick for my laser? What mm/m should I be running? Newbie here so any advice is appreciated.

Struggling with a cut on 3mm Birch - Tips and Tricks - LightBurn Software Forum

Best settings to cut 6mm plywood - Sculpfun - LightBurn Software Forum

Cut through plywood is inconsistent - Ruida controllers - LightBurn Software Forum

Consistency of cutting 3 mm plywood - LightBurn Hardware Compatibility - LightBurn Software Forum

Consistency of cutting 3 mm plywood - LightBurn Hardware Compatibility - LightBurn Software Forum

Sudden speed changes on curved sections only - Troubleshooting - V1 Engineering Forum

Consistency of cutting 3 mm plywood - LightBurn Hardware Compatibility - LightBurn Software Forum

Cut through plywood is inconsistent - Ruida controllers - LightBurn Software Forum

Cant cut 3mm plywoodwhy? : r/lasercutting

Cutting through wood with Lightburn - LightBurn Software Questions - LightBurn Software Forum

Consistency of cutting 3 mm plywood - LightBurn Hardware Compatibility - LightBurn Software Forum

Optimized cut settings - LightBurn Software Questions - LightBurn Software Forum

Cutting plywood - LightBurn Software Questions - LightBurn Software Forum

Cutting 3mm plywood - Common Problems - LightBurn Software Forum