Basics: 5 ways of getting your 3D prints to stick!
My biggest print yet, done in 3 prints, overall it was 45 hours of printing. There are some weird lines near seam on the holes but i can live with it. : r/Ender3S1
My biggest print yet, done in 3 prints, overall it was 45 hours of printing. There are some weird lines near seam on the holes but i can live with it. : r/Ender3S1
Bokuwadoctorchopper (u/Bokuwadoctorchopper) - Reddit
P1s Severe warping/deformed prints on left back edge of build plate - Troubleshooting - Bambu Lab Community Forum
Yellow PETG adhesion/density issues around layer 3-5 – Assembly and first prints troubleshooting – Prusa3D Forum
My biggest print yet, done in 3 prints, overall it was 45 hours of printing. There are some weird lines near seam on the holes but i can live with it. : r/Ender3S1
I'm printing out every Pokémon in 1mm:1in (1:25.4) scale and painting them. Here is part 3, #0001 - 0082! : r/pokemon
Adhesion problems and solutions in FDM 3D printing
prusa i3 - Issue with PETG adhesion - 3D Printing Stack Exchange
Do I have a problem with adhesion? I'm trying to print a Golden Snitch wings, I managed to make one, but the other attempts were all failures The last pic is a
Prusament Viva La Bronze printing issues – General discussion, announcements and releases – Prusa3D Forum