PVA, or polyvinyl alcohol, should be used with our #1016 Partall Wax for the easy release of parts from a mold. Wax should be applied to the mold, 3–4 layers thick, and buffed to a high gloss. Once the final layer of wax has dried, PVA should be applied with the following considerations:PVA can be brushed on, but for best results, apply with a spray gun, 12–18 inches away from substrate. Generally, apply in three layers: the first, a thin mist, allowing 10-15 minutes to dry completely.
Fibre Glast - PVA Release Film
Mold Releases, Mold Release Spray & Parting Wax
FibreGlast 2023-2024 Catalog, PDF, Fiberglass
SLIDE® Urethane Mold Release No. 45812H
Easy homemade mold release agent
Formulated especially for mold making and casting, and works well with most liquid rubber and liquid plastic products It will release mold rubbers
Universal Mold Release - 14 Fluid Ounce Aerosol Can
Adhesive Guru Silicone Mold Release Aerosol Spray (13.5 fl oz) Lubricant Agent for Epoxy Resin Molds (1 Pack)
Mold Releases, Mold Release Spray & Parting Wax
GET THE JOB DONE: Selsil Mold Silicone Mold Release Spray is convenient, multi-functional spray release agent, ideally suited for a lot of molding
SELSIL Silicone Mold Release Aerosol Spray (13.5 fl oz) Professional Resin Mold Releaser, Non-Stick, Fast-Drying & Easy Mold Removal, (Pack of 1)
Mold Releases, REXCO, Partall, PVA, Stoner
Stoner G402 Nix Stix X-9032A Mold Release
FibreGlast 2023-2024 Catalog, PDF, Fiberglass