Engraving paper - Ortur Lasers - LightBurn Software Forum

Hello, I’m trying to make earring cards with text engraved on it and sometimes it engraves okay, other times it’s missing chunks of letters. This was my very first try and it went perfectly! It was subtle enough and looked really good! Next, it didn’t go so well. I tried engraving 4x with the same settings and you can see what’s wrong. Then I also tried all the other settings, but I can never get it the same as on the first picture. It either looks too dark and burned too deep or it miss

Limited Offer On Ortur Laser Engraving Machines exclusively on Madethebest

Accuracy in line mode - Ortur Lasers - LightBurn Software Forum

Engraving detail please help - Ortur Lasers - LightBurn Software Forum

Lightburn engraving not producing accurate burns with Ortur Laser - Ortur Lasers - LightBurn Software Forum

Ortur laser master 3 cutting problems - Ortur Lasers - LightBurn Software Forum

Ortur Laster Master Pro 2 - Lack of power? - Ortur Lasers - LightBurn Software Forum

Ortur laser stops engraving, software issue? - LightBurn Software Questions - LightBurn Software Forum

Laser engraving on a slant - Ortur Lasers - LightBurn Software Forum

Inconsistent laser intensity on surface - Ortur Lasers - LightBurn Software Forum

Test Pattern for burning using Ortur LM2 - 15w Laser - Finished Creations - LightBurn Software Forum

Image and line trace engraving will not align. Help - Ortur Lasers - LightBurn Software Forum

Alarm 3 in Lightburn in the middle of job - Board Configuration and Setup - Cohesion3D Community