Siser EasyWeed Purple HTV OVERSTOCK SALE –

(264)

Write Review

$ 0.50

Add to Cart

Qty

In stock

Description

This backing can be peeled hot or cold and doesn’t lift during weeding. It’s also extremely durable wash after wash. It has a pressure sensitive carrier that allows you to offer detailed designs on a wide variety of fabrics. This is CPSIA Certified Recomended Cut Settings *Suggestion only, used for a starting point. Yo
This backing can be peeled hot or cold and doesn’t lift during weeding. It’s also extremely durable wash after wash. It has a pressure sensitive carrier that allows you to offer detailed designs on a wide variety of fabrics. This is CPSIA Certified Recomended Cut Settings *Suggestion only, used for a starting point. Your settings may need to be adjusted from here. We always suggest test cutting to find the best settings for your individual machine* Cricut®: Blade: Standard Setting: Iron-on Silhouette Cameo: Blade: Standard, 3 Setting: Heat Transfer Material (smooth) Speed: 8 Thickness: 6 Brother: Blade: 2 Cut Speed: 1 Cut Pressure: 1 Application Instructions (heat press) • Cut in reverse• Weed excess material • Preheat garment for 2-3 seconds • Cover design with Teflon cover sheet • Apply design at 305° • Use medium pressure for 10-15 seconds • Peel carrier hot or cold Application instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Teflon cover sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds • Peel carrier hot or cold Applies to: 100% cotton Poly/cotton blends 100% polyester Leather Laundering: Wait 24 hours before 1st wash Machine wash warm or cold / mild detergent Dry on normal dryer setting Do not dry clean Size is +/- .5 inch on width, +/- 3% on length Colors of products may be different than what the screen on your device shows. TIP: Always perform a test cut prior to cutting a whole design.