Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t
Scanning Offset Adjustment help - LightBurn Software Questions - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware
Circle trouble - beginning and end are offset - LightBurn Hardware
xTool D1 Pro 20W Review - Mandala Art with a 20W laser engraver and cutter - CNX Software
Critical issue with new version 1.2.01 -- OFFSET + file compatibility - LightBurn Software Questions - LightBurn Software Forum
Unround / Unclosed circles on sculpfun s30 pro with expansion - Sculpfun - LightBurn Software Forum
Camera alignment drifting - LightBurn Hardware Compatibility - LightBurn Software Forum
New user offset problem - LightBurn Software Questions - LightBurn Software Forum
Edges/offsets in circles depending on it's starting point (backlash?) - LightBurn Hardware Compatibility - LightBurn Software Forum
Critical issue with new version 1.2.01 -- OFFSET + file compatibility - LightBurn Software Questions - LightBurn Software Forum
Problems with AtomStack A10 Pro - LightBurn Hardware Compatibility - LightBurn Software Forum
Circles not round - LightBurn Hardware Compatibility - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum
Can not find the correct origin on new machine - LightBurn Hardware Compatibility - LightBurn Software Forum
Scan offset not funtioning even after device removed and reconfigured - Ruida controllers - LightBurn Software Forum