Creality Falcon 2 - 22 W is crashing into the frame - GRBL - LightBurn Software Forum

Hey everyone! I’ve had my Falcon 2 for maybe 6 months and it’s worked fine so far. Then a couple days ago I went to run a file. I put the SD card in place, turned the machine on, pressed the Frame button… all was good… then I hit the start button and the module flew back to the home position and crashed into the frame. In the video below it doesn’t crash as hard as it does occasionally. I updated the firmware, I tried running older gcode files that have worked before, turned t

Creality Falcon2 40W Laser Engraver & Cutter - Creality Falcon

Review: Creality Falcon2 Laser Cutter/Engraver

Creality Falcon2 22W Laser Engraver - Community Laser Talk - LightBurn Software Forum

Laser is cutting thru pieces and dead areas - LightBurn Software Questions - LightBurn Software Forum

Creality Falcon 10w strange draw - LightBurn Bridge - LightBurn Software Forum

User Manual Creality Wiki

Clearity Falcon 10w burnouts at left and right side - GRBL - LightBurn Software Forum

Creality Falcon2 22W Laser Engraver - Community Laser Talk - LightBurn Software Forum

Creality CV-30 Laser Falcon 5/10 Watt home/entry level Engraver/cutters, Page 2

Misalignment between the trace and the actual laser - GRBL - LightBurn Software Forum

Error:20 Unsupported or invalid g-code - LightBurn Software Questions - LightBurn Software Forum