My first attempt at casting with moulding compound and Milliput to make terrain details. It came out much better than I expected, but I need to figure out a way of dealing

Creating surfaces

Creating surfaces

Week 6

How do we feel about a suction cup this size? to be printed on an anycubic photon mono x 6k. support to be added, rn just foccusing on the angle. i printed

Modern Synthesist: How to Sculpt Miniatures 2: How to use Epoxy Putty, Greenstuff, Apoxie Sculpt

How do we feel about a suction cup this size? to be printed on an anycubic photon mono x 6k. support to be added, rn just foccusing on the angle. i printed

Resin bubbles forming after its already in the mold? : r/ResinCasting

I'm trying to make a hollow pumpkin by pressing a sheet of clay into this mold. I was successful, but ran into a lot of problems. : r/polymerclay

How do we feel about a suction cup this size? to be printed on an anycubic photon mono x 6k. support to be added, rn just foccusing on the angle. i printed

Dirty pour experts, how do you keep your colors from bleeding into one another? I can get cleaner layers by letting the resin thicken, but then I can't get as many swirls/layers.

Any good tips to share about casting / moulds? : r/TerrainBuilding