Extruder keeps slicing the filament. This print has a ton of retraction. Should I just lower the retraction rate significantly or is there a way to loosen the group between the extruder

print quality - Under extrusion when starting outer wall - 3D

creality ender 3 - I have one print that's underextruding, what

3D Printer Retraction Speed – Simply Explained - FacFox Docs

Dual V3 - A Review - Wait for V4? - Heat Creep Still A Problem

Hot to get constant print / extrude speeds – PrusaSlicer – Prusa3D

Printing with polymax PC on a Garalyte steel sheet. Temp at 270C and bet at 115C. It is in an lack enclosure. After a few min into the first layer the extruder

The Ultimate Guide to 3D Printer Extruder - DYZE DESIGN

Polymers, Free Full-Text

A Guide to Understanding the Tolerances of Your 3D Printer

Found this screw halfway out in the middle of a print job. Is this

After multiple retractions, the filament jams. Ive tried

Filament sensor causing under extrusion : r/FixMyPrint