Creality Falcon 2 Frame is Incorrect - LightBurn Hardware

If I set LightBurn to Current Position and then set the Job Origin to anything but the lower left corner, the machine frames in the wrong place. It always frames as if it were starting from Current Position but with the Job Origin in the lower left corner. I’m using a 22W Creality Falcon 2. I’m using G-Code files instead of a USB connection. Below is a picture of a scrap piece of cardboard I was running tests on to figure out alignment. You can see my pencil marked X, whcih I was trying to hit

Why doesn't light burn connect to my Creality Falcon 2 22w laser

Creality falcon 2 not connecting - GRBL - LightBurn Software Forum

This item is 100% Creality Laser Engraver. 【22W Creality Falcon2 Laser】Utilizing the most up-to-date FAC spot compression technology, 4pcs 6W laser

Unrepaired Creality Falcon 2 Laser Engraver 22W Falcon2 Cutter Machine

CR-Laser Falcon - laser wont fire - LightBurn Software Questions

【Powerful Laser Cutter】With 10W output power, CR-Laser engraver can cut through 12mm wood board with one pass at a speed up to 10000mm/m. Even

10W Laser Engraver, Official Creality CR-Laser Falcon 72W Engraving & Cutting Machine, 0.06mm High Precision Laser Cutter for Cardboard, Wood

Wrecking a (scrap) YETI on Falcon 2 40W and Creality Roller. : r

Wrecking a (scrap) YETI on Falcon 2 40W and Creality Roller. : r

Wrecking a (scrap) YETI on Falcon 2 40W and Creality Roller. : r

Cr-Laser Falcon Owners and Support

Creality 5W Falcon Laser Not Discoverable with Mac OS, Firmware