That adjustment should be set once and left alone. Use lightburn to control the lps via the controller. If you change that adjustment it will throw off all of your known power settings. This might help… Good luck 😸
K40 new “omtech board upgrade (smoothie)” - GRBL - LightBurn
Smoothieboard communication errors - [SOLVED] - LightBurn Hardware
Laser Smoothies At Maker Faire
MKS DLC32 V2.0 fitment to K40 - Wiring and Initial setup
Smoothieware on omtech k40, lightburn not controlling laser power
K40 homing in wrong spot - LightBurn Software Questions
Smoothieware on omtech k40, lightburn not controlling laser power
K40 Laser not Responding with laserburn - Board Configuration and
What is wrong with these lightburn command lines - Board
MKS DLC32 vs M2 - #18 by DougL - GRBL - LightBurn Software Forum
Smoothieware on omtech k40, lightburn not controlling laser power
K40 new “omtech board upgrade (smoothie)” - GRBL - LightBurn
Circle width/height not making circle when set the same problem